grow room design

SDSativa

SDSativa

Active Member
Hey guys, I'm gonna be converting my shed to a growroom here in a little bit, and would like some advice on design and setup. The shed is 9 ft W x 11 ft L x 10 ft H. I would like to utilize the whole shed and create a flowering room, mother room, clone/preflowering, and room for the a/c, co2 etc. I drew up a little sketch and would like to see what you guys think. Sorry for the bad pic, but this was the only way I could give you guys an idea of what ive been thinking.
 

Attachments

SDSativa

SDSativa

Active Member
I would like to use a 14000btu A/c for the whole shed. Also a co2 generator and dehumidifier. I want to make it completely sealed so I won't have to worry about smell, and make it easier to control the environment.
 
SDSativa

SDSativa

Active Member
thanks for the replies. The shed is still full of crap at the moment. I will be cleaning it out over the next few weeks and trying to get all the equipment. I'll take some pics tomorrow and you can see the progress.
 
SDSativa

SDSativa

Active Member
Done working today, but I'm gonna be back on it tomorrow. I need to make some room in the garage for the rest of the crap. Then I'm gonna tear down those shelves, seal the room, and bomb it. I won't put any plants in for atleast a weak after I bomb it. It will give me time to gather equipment and set up the grow.
 
megs

megs

Active Member
I can't wait to see it up and running man. How are you planning on sealing the whole shed? Are you going to be using/running a carbon filter/ozone generator? How many plants? What type of lights/power? Clones or seeds? What strand?
 
megs

megs

Active Member
Sorry for the double post but is there even power to the shed? If not are you going to plan on running a generator or something?
 
SDSativa

SDSativa

Active Member
Hey megs. The shed is only about 15-20' from the house, So I am going to have a 60 amp breaker installed just for the shed. As with sealing it. I'm gonna clean the crap out of it, line it with black plastic, then with block ir, then with white poly. I hope this will keep it sealed.
I will be running 2 3x3 tables(DIY) for flowering. Staggering the flower times so I harvest 1 table a month. The mother plants will be in a 12 site ebb and flow unit. I will also have a 2x4' table for the preflowers, and above that a station for clones.
I will be using the CAP Complete Greenhouse Controller for the lights, pumps, and humidity. A 430w and 600w over the 3x3s. A 1000w MH over the mothers, and 4' fluoro's for the preflower and clones. I have my Caregivers license and am qualified to grow 18 flowers. 9 in each 3x3, then 6 mothers. I am going to start with some white rhino I got from netherlandseeds, but would like to get some white widow max, and some Arjan's ultra haze #1.
 
You must log in or register to reply here.
Top