THCV Victory (Dutch Passions) / Maui MAC Burger / GDP x Black Willie

N

NeuroticTurtle

Active Member
Started under an Equinox 1000 quantum style board, moved to new 730W spider farmer SE7000. Currently on day 6 of flowering @ 12/12. Currently 8" from the victory's canopy at 100% output. She jumps an inch or three every day, so I'll be raising the light a couple times this week. Topped, very lightly trained, lightly lollipopped for clones and prevention of larf.
IMG_20220922_191535RIU.jpg
IMG_20220922_202247RIU.jpg
GDP x Black Willie seedling, ready for repotting once it shows
IMG_20220922_020848riu2.jpg
the Maui MAC Burger:
IMG_20220920_191242riu.jpg

Soil is bog standard pro-mix, starts at 4-4-4, added daily House & Garden Van de Zwaan Soil A&B nutes with a bit of daily Technaflora magiCal and either GH Floralicious Plus or GH hard water micro nutes added in alternation. Once I switched from the old light (468W draw) to the new one (730W) she started running into some mag deficiency and near doubled her growth for a bit. No clue as to real PAR or Lux values. I've got a lux sensor on the way but it isn't in yet and the apps on my phone hit the luminance limit of the phone's sensor pretty quick. Temps are about 21-23C, and the air flows 24/7 with RH35%.
 
N

NeuroticTurtle

Active Member
Psyphish said:
The THCV strain is very interesting, please write about the effects after you're done curing.
Click to expand...
Oof, it might have to wait for the next wave of clones for a proper cure if you're looking for a real smoke report. I don't typically exercise patience when it comes to curing, as most of the thcv strains I've grown tend to taste best when 'fresh' anyways. The black willie gives notes of bubblegum and armour-all, the lemon stilton was a lemon-y creamy dream. The trainwreck x Black willie had more pine than armour-all.
 
N

NeuroticTurtle

Active Member
IMG_20221003_021610riu.jpg
Just added the Solacure Farm & Ranch UV bulbs back into the mix, bit far from the central canopy yet, but maybe I can sling them inbetween the bars of the SE7000. One of these days I'll invest in a trellis too.
 
N

NeuroticTurtle

Active Member
The UT-383BT mini lux sensor arrived today, it paired nicely with the ppfd app, but didn't have a 100% applicable profile for the SE7000, since it uses a mix of 2800k-3200k and 4800k-5000k, with 660nm thrown in. I could only get it to read 1350umol/s peak with the 3500k+10% 660nm profile. I'll probably calibrate the app to 1525ish @8" off the par chart and go from there, but it was fun to get baseline readings. Currently the flowering tent is at peak brightness at main canopy height, approx 950 umol/s uncalibrated at the height of the GDP x BW, bit higher for the other seedlings in the flower tent. Checking the veg room I found approximate values of 1050 umol/s for the canopy height of the thcv victory clone momma under the Equinox 1000. Seedlings and clones at about 300-400 umol depending on placement.

THCV Victory clone momma, doin a last stretch after getting topped one last time:

IMG_20221004_192024.jpg
 
N

NeuroticTurtle

Active Member
IMG_20221005_212358crop.jpg

moved the THCV Victory clone momma into flower, stuffed the GDP x BW into the corner, and culled two more males from the seedlings.
 
N

NeuroticTurtle

Active Member
ooh baby, there's a light dusting of trichomes on some of these sugar leaves, Day 23 of flowering, 12/12 UV supplementation from Solacure Farm & Ranch bulbs.

IMG_20221009_002321crop2.jpg

edit: 10/09 for getting photo to display maybe.
 
Last edited:
You must log in or register to reply here.
Top