I need all of the help
- Thread starter Spliffboy37
- Start date
GreezzyGuy
Active Member
To late to repair, but no problem, just feed with phed water until done
Looks like you where cranking on them.
Looking yummy yummy
Looks like you where cranking on them.
Looking yummy yummy
Spliffboy37
New Member
Any idea what this shit is?
Budzbuddha
Well-Known Member
Could be light burn - seems to affect upper leaf areas.
GreezzyGuy
Active Member
Looks like they are throwing up.full of nutes that deep into budding .
What was the run off pH and ppm.
Maybe start flushing a week earlier next time.
They look fine,just maybe timing issue on reading the plant.
What was the run off pH and ppm.
Maybe start flushing a week earlier next time.
They look fine,just maybe timing issue on reading the plant.
GreezzyGuy
Active Member
I thought that also but he is running led doubt they got that hot.
GreezzyGuy
Active Member
And I hate when that happens burnt crumbly leaves on sticky girls make trimming obnoxious.
GreezzyGuy
Active Member
Yes sir looks tasty. When you roll one up to smoke ,yell my name
Spliffboy37
New Member
Not sure on runnoff of those, although my other veg ones had runoff of 6.2. These were supposed to go 9 weeks, so idk about timing
GreezzyGuy
Active Member
Do you crank on them until the end?or back after they quit swelling?
Budzbuddha
Well-Known Member
Light burn ( stress ) can happen with intense led systems. 1500 ppm isnt too crazy on them , but leaf symptoms also mimic what a potassium deficiency looks like also …. Yellowed margins and necrotic tips.
Noticed many white pistils left so there some weeks to go still.
Noticed many white pistils left so there some weeks to go still.
GreezzyGuy
Active Member
Maybe light burn .
Usually on a potash def they become more spindly And targets from the bottom up. .
What was the npk of your feed. Give us a better idea
Usually on a potash def they become more spindly And targets from the bottom up. .
What was the npk of your feed. Give us a better idea
GreezzyGuy
Active Member
And what is the molybdenum and manganese, and iron .
Spliffboy37
New Member
How far do you think the lights should be? And not sure about deficiency because I am using the cyco feed chart
Spliffboy37
New Member
I am no pro. I use basic cyco feed chart, which should be giving all the nutrients needed
