Driver mounting and thermal paste

[Rdot03]

I'm currently building my grow space and wanted to know if it's safe to mount meanwell drivers to a wall and what's the best thermal paste to use for cobs that may be ran up to 100w?

 

[nevergoodenuf]

Arctic Silver. You may need the driver in the grow area? You want fresh air and a temperature in the low 80*f.

 

[Rdot03]

The space is a 10x17 but flower will be a 5x10 space room will have a mini split inside.

 

[Rdot03]

Arctic Silver. You may need the driver in the grow area? You want fresh air and a temperature in the low 80*f.

Ok that AS5 what about the thermal grizzley Kryonaut?

 

[nevergoodenuf]

The mini split won't be needed unless your over 45watts sq/ft or if your sealed and running CO2( added dehumidifier heat). Most any quality paste will be fine.

 

[Rdot03]

The mini split won't be needed unless your over 45watts sq/ft or if your sealed and running CO2( added dehumidifier heat). Most any quality paste will be fine.

Full throttle I'd be pushing 2237w with 2 fixtures so that's around 45 a sqft. My summers are terribly hot so I'll definitely need it then

 

[Rdot03]

But I want to mount my drivers to the wall bc I have 6 is that ok

 

[nevergoodenuf]

Unless you are growing monsters, that is way more light than I would use. I usually run about 30w sq/ft. This run is 20w and is looking better than my last at 30w. The drivers on the wall should be fine, but space them off for airflow and have a fan sweep past them. A bit of air will drop temps on the whole lighting system. In the 100*s hear and tent stayed mid to low 80*f all summer.

 

[Rdot03]

Well I'm trying to replicate a timber fatty vs. I figure have more and not need than not enough..

 

[Lucky Luke]

I used red silicon, the kind u use for making engine gaskets. Couple years later and no problems at all.

 

[Renfro]

Use Arctic silver thermal paste and use chip holders, they aren't expensive.

Mount your drivers on the wall, thats fine.

 

[Rdot03]

Use Arctic silver thermal paste and use chip holders, they aren't expensive.

Mount your drivers on the wall, thats fine.

I have the vero 29c se