33k potentiometer help

[Rdot03]

Can anyone reccomend a 33k potentiometer I have 3 hlg 480 1750b I want to connect together.

 

[Airwalker16]

Can anyone reccomend a 33k potentiometer I have 3 hlg 480 1750b I want to connect together.

I think I read on the 3-in-1 dimming thread by Stardust Sailor you wanna use 46K pot?
But a 33K pot is near impossible to come upon. Closest will be 35K.

 

[Rdot03]

I think I read on the 3-in-1 dimming thread by Stardust Sailor you wanna use 46K pot?
But a 33K pot is near impossible to come upon. Closest will be 35K.

I have no clue. I just read i need a 33k for 3 drivers. How could i make a 46 work?

 

[Rdot03]

Will this work?

 

[1212ham]

It will. 35k is also good, if not better.
https://www.rollitup.org/t/meanwell-led-drivers-3-in-1-dimming-function.838760/

 

[Airwalker16]

Ya beat me to the link , Ham. Hahaha

 

[Airwalker16]

Will this work?

That'll work perfectly.
Not sure with the larger 320, 480, & 600 sized drivers if you're supposed to use a resistor on the white dim lead. It would be 3.6K Ohm sized one since it skips between 3.4-3.6.
Very cheap and easy to buy online as well.

 

[Rdot03]

If I ran no dimming and the fixture im building is full cycle couldnt I just raise the light higher than normal to veg until they are strong enough to lower the lights back down

 

[PSUAGRO.]

If I ran no dimming and the fixture im building is full cycle couldnt I just raise the light higher than normal to veg until they are strong enough to lower the lights back down

Yes

 

[Airwalker16]

If I ran no dimming and the fixture im building is full cycle couldnt I just raise the light higher than normal to veg until they are strong enough to lower the lights back down

Ya, but dimming is a lot smarter.

 

[Rdot03]

Ya, but dimming is a lot smarter.

Understood the diy part is easy to me just getting the right information is sometimes hard. And that's where I am.

 

[Rdot03]

I read that thread but still was a bit confused after. Maybe I have to read it again