Remote driver help

[SayChowda]

How many drivers can I splice together? 4 HLG 320h-c1400b running to 2 4x4 photo boost strip builds. I would like to make wiring harnesses for remote drivers. How many power leads and dimming leads can I splice together in a project box with wagos from the driver and then a wiring harness to my lights.

 

[Airwalker16]

How many drivers can I splice together? 4 HLG 320h-c1400b running to 2 4x4 photo boost strip builds. I would like to make wiring harnesses for remote drivers. How many power leads and dimming leads can I splice together in a project box with wagos from the driver and then a wiring harness to my lights.

I'd do 2 320's per box and just have 2 separate fixtures for each 4X4.
You could hook up all 4 but that's a lot to pull through one power cord.

 

[SayChowda]

I'd do 2 320's per box and just have 2 separate fixtures for each 4X4.
You could hook up all 4 but that's a lot to pull through one power cord.

What about the dimming leads? Can I splice all 4 dimming leads to a trolmaster controller or dimmer switch

 

[TEKNIK]

The 1-10v side can all be wired together without a problem. Last time I check upto 30 can be connected to one pot

 

[Airwalker16]

What about the dimming leads? Can I splice all 4 dimming leads to a trolmaster controller or dimmer switch

You can put them all into one single 25K potentiometer, yes. Needs to be 25K ohms though.
But like I said, I'd use 2 drivers per fixture and just connect those 2 together using a 50K ohm potentiometer for each pair of drivers.