Understanding PPM

HydroRed

Well-Known Member
I just received my data logger and I'm trying to understand what its telling me. It said to turn it on and it would calibrate itself. This is the room that my 5×5×8 tent is in.
Its telling you that the room temp is 74.1*F, your Relative Humidity (RH) is 26% and that the concentration of Co2 is at 3290 ppm (parts per million). I dont believe the meter is calibrated yet on the ppm though. Average room ppm for CO2 is around 400-900. Ideal range for most Co2 setups is between 1200-1500 ppm. How long did it say in the directions to give it to "self calibrate"?
 

Bernie420

Well-Known Member
That's what I thought was odd as well. It says to plug it In and it does a countdown from 10. After that is says it requires "no initial setup or calibration"

My tent pulls air and vents into the same room.
Is there a decimal point missing between the 9 and the 0?

329 sounds reasonable but 3290 = no way
 

Renfro

Well-Known Member
PPM indoors can get very high. Many older houses don't have a fresh air intake in the central air system. This combined with people exhaling, pets, gas ranges and the like can make for some really high indoor readings. Indoor air quality is enhanced by having a fresh air intake on a central air system.
 

redivider

Well-Known Member
3290 is dangerously high.

anything over 1000ppm co2 and I want supplemental oxygen available nearby, and a spotter outside just in case I get dizzy.... my former employer gave me confined space training....

Over 2.000 and you need hazmat type gear..... 3290 this guy would be passed out on the floor.... there would be federal investigations as to why he's about to die...

if you are pumping co2 into that room without a monitor and you're getting this reading open the damn windows quick.

I agree something's off on that...
 

HydroRed

Well-Known Member
The outdoor ppm readings seem a lot more accurate. After you bring it back in, does it level off to an acceptable number or does the ppm shoot up to astronomical numbers again?
 

Renfro

Well-Known Member
If occupants are tired a lot, it can be caused by high CO2 levels. Natural gas and Propane when combusted produce a lot of CO2. If the unit has bad burners or some other fault then co2 can be vented into the home along with CO.
 

ttystikk

Well-Known Member
If the OP gets dizzy in the house that's a serious problem.

1500ppm is fine for humans and represents the upper limit for CO² augmentation.

The best results seem to come from intermittent supplementation; keep the normal level about atmospheric, then boost the level up to your desired Max once or twice during the lit portion of your cycle.
 

MR.NICE.GUY.1990

Well-Known Member
My house was built in 2007. After talking to my father, he said that the entire house is relatively sealed up to protect against the frigid winter air. I opened a window. Opened it only 7 inches but it's a 5ft tall window
 
Top