fragileassassin
Well-Known Member
The pipe valve is to replace the control res. I will set the system level with that valve and it will keep it there from a top off tank. I wanted to eliminate using both a control res AND top off tank like I did with the big system. With what I've experienced with water temps down there so far, the pump not being in the water plus the waterfall sprayers with such a high rate of circulation should keep the water temp in the system right around 70F. Goal is bennies and no chiller, well see how that goes.Looking good. I've broken so much stuff....
I was going to suggest that you could buy the 10' pvc sticks and cut them in half at the store to get them home. If you know your longest measurement you can cut it to that, I do it for wood sometimes.
What determines your water level in the buckets, the amount of water in the system?
Do you have a reservoir?
That is what I did today, i went and got a 10ft pipe and cut it in half in the parking lot. Only to get home and go to start cutting it to size and realize it's the wrong size so I had to go back and do it again and then was 3" short.