Beachwalker
Well-Known Member
In a five-by-five tent a dimmable thousand watt hid works well for me, it adds much-needed heat in the cold Winters and allows me to dim it down in the hot summers
-good luck
-good luck
You would have been better off getting a DE 750 or a 630 CMH. Those Mars panels are garbage. The only reason they are running cooler is because they are half the wattage of your former HID. If you had replaced it with 1000 actual watts of mars, it would be just as hot.Led is not measured by watts. When they say 600watt led its only to reference the comparative light out put. The 1000watt full spectrum HPS light i was running pulled 1000watts from the wall + the watts needed to run the ballast (150watts) + 1400btu a.c. unit + the inline cooling fan + the two small fans to move the air around = to much fucking money .. so i pulled it out did a lot of studying and came up that leds are the way I'm going. I got two mars hydro full spectrum 600watt leds out put is compared to a 600watt HPS but with way more UV-B (red light you need to promote photosynthesis) 1 600watt pulls 260watts from the wall so thats 520watts on lights yea they do run a bit hot but but not even close to what a thousand watt HPS light would put out so I removed the 1400 BTU AC unit catch the inline fan and my carbon scrubber just two exhaust and my two fans for air movement that saved me so much money on electricity and kept me lower under the radar
Please stop.And for the record im not saying LED is better or is not better than HPS im saying it is better in the consumption of power compared to out put. But i will say this LED is scientifically designed to put out the UV spectrum that plants need and thrive in. They work for me do the research and come up with your own opinion I would say if you are a small casual tent grower LED maybe a viable option due to the power consumption heat output and color spectrum
Watts is a measure of energy... LEDs cannot produce light energy without being provided electrical energy... LEDs must follow these same laws of physics... The comparative light output is an estimate that I don't believe is grounded in science... LEDs have an efficiency advantage over HPS but the advantage is finite and, from what I can tell, way overplayed by the LED industry. In addition, the disadvantage LEDs have in reproducing the full complement of spectrums in sunlight is a huge, ignored disadvantage for LEDs... As LED systems add more light spectrums, they are getting closer to approximating sunlight but, IMO, they do have some way to go... The OP is just trying to light her tent as efficiently as possible and has reached out for help... As I've seen too often, an LED fan promises the same growth as HPS with half the cost... That is not possible with current technology... Everyone wants to save money on energy but if the actual equivalent LED system cost 10 times as much, the energy savings don't pay off the initial expense years down the road... Best of luck!Led is not measured by watts. When they say 600watt led its only to reference the comparative light out put. The 1000watt full spectrum HPS light i was running pulled 1000watts from the wall + the watts needed to run the ballast (150watts) + 1400btu a.c. unit + the inline cooling fan + the two small fans to move the air around = to much fucking money .. so i pulled it out did a lot of studying and came up that leds are the way I'm going. I got two mars hydro full spectrum 600watt leds out put is compared to a 600watt HPS but with way more UV-B (red light you need to promote photosynthesis) 1 600watt pulls 260watts from the wall so thats 520watts on lights yea they do run a bit hot but but not even close to what a thousand watt HPS light would put out so I removed the 1400 BTU AC unit catch the inline fan and my carbon scrubber just two exhaust and my two fans for air movement that saved me so much money on electricity and kept me lower under the radar
I think the CMH light salesman just pops in to promote his product on every light thread...Heat issues in a tent with a DE CMH at that wattage?
I might be more inclined for an open area grow with more then 8 ft of ceiling height.....10 would be minimum, I would think....
you are forgetting savings on AC or fans to cool HPS, and cost of bulb replacements.Everyone wants to save money on energy but if the actual equivalent LED system cost 10 times as much, the energy savings don't pay off the initial expense years down the road
I responded to your statement, "LED is not measured by watts", which I took to mean LEDs don't follow the laws of physics, an incorrect statement. I agree that a 1000 watt HID in a 5 x 5 will pose heat challenges that are exacerbated by the tent height... the plants will need to be kept 18-24 inches from the light... I think a 600 watt HPS is a little under-powered for a 1.5m sq tent. A thousand watt HPS with a digital ballast may allow better targeting of the sweet spot between lighting the tent fully and saving energy...I never promoted LEDs or said they were better notice how i said in my opinion and it works for me. And yes i know watts are measurement of power my friend the luminous put out by a led is compaired to the out put of a light That uses 600watt of power 1 600watt i use puts out a little over 12631 lumens . And in my opinion a 1000watt full spectrum HPS light is a bit much for a 5x5 i speak from experience. When they grow taller you will run out of room and wont be able to get your light high enough and will get light burns or stress. LeD is a alternative if u cant run HPS read my posts and you will see what I am saying people
I fully agree with u on that. My only concern is that 1 bulb last 4 flowerings at best more like 3 and the dig. Ballast i have can run 750watts but have u seen a 750 full spectrum HPS bulb.? So i could run a 1000watt bulb and not get the full potential of the spectrum. As it never gets to the required temp to get that full spectrum. But seems we are going down the rabbit hole here. The question was whats the best lighting for her 5x5 tent. In my OPINION its 2 600watt marshydro full spectrums LED. Every one may disagree but with the advancement of LED lights more and more top growers are switching to LED. Im just giving the facts. Reason why i feel led is better for a tent is thisI responded to your statement, "LED is not measured by watts", which I took to mean LEDs don't follow the laws of physics, an incorrect statement. I agree that a 1000 watt HID in a 5 x 5 will pose heat challenges that are exacerbated by the tent height... the plants will need to be kept 18-24 inches from the light... I think a 600 watt HPS is a little under-powered for a 1.5m sq tent. A thousand watt HPS with a digital ballast may allow better targeting of the sweet spot between lighting the tent fully and saving energy...
They dont run cooler they run hotter than most led and garbage? They are one of the top rated led makers 4.5 out of 5 kinde being 1stYou would have been better off getting a DE 750 or a 630 CMH. Those Mars panels are garbage. The only reason they are running cooler is because they are half the wattage of your former HID. If you had replaced it with 1000 actual watts of mars, it would be just as hot.
And no, those panels are not equivalent to 600 watts. They are equivalent to the 260 watts that they actually draw. The efficiency of cheap, blurple panels is roughly equivalent to SE HID.
only crummy led companies do that because most consumers know leds are power efficient but not many know how much more efficient and they prey on that. mars hydro 600 is a 280w blurple led and its ppfd measurments put it on par with about 350w worth of hps. viper isnt much better than mars. As for the 630 cmh above.... love my 630 de cmh but that one seems a bit high priced.Led is not measured by watts. When they say 600watt led its only to reference the comparative light out put. The 1000watt full spectrum HPS light i was running pulled 1000watts from the wall + the watts needed to run the ballast (150watts) + 1400btu a.c. unit + the inline cooling fan + the two small fans to move the air around = to much fucking money .. so i pulled it out did a lot of studying and came up that leds are the way I'm going. I got two mars hydro full spectrum 600watt leds out put is compared to a 600watt HPS but with way more UV-B (red light you need to promote photosynthesis) 1 600watt pulls 260watts from the wall so thats 520watts on lights yea they do run a bit hot but but not even close to what a thousand watt HPS light would put out so I removed the 1400 BTU AC unit catch the inline fan and my carbon scrubber just two exhaust and my two fans for air movement that saved me so much money on electricity and kept me lower under the radar
LED components are far more expensive than HPS... While LEDs are solid-state, the number of components in the system is significantly higher. This higher component count leads to to a lower mean time between failure (MTBF)... In theory, a lower MTBF means the system will fail more frequently... I have experienced more failures with LED than HPS and I use LED very little. (Sometimes theory and reality match...) I've never broken an HPS bulb over the last six years... I must not be as clumsy as I thought! You seem to be under the impression that LEDs magically give you light energy without electrical energy... sorry to burst your bubble! Many LEDs caution you not to run them more than 12 hours on-time making these useless for veg... Considering how well they make my flowering plants grow leaves I would definitely use them in veg... (I want a light that makes my plant grow flowers... Best of luck!I fully agree with u on that. My only concern is that 1 bulb last 4 flowerings at best more like 3 and the dig. Ballast i have can run 750watts but have u seen a 750 full spectrum HPS bulb.? So i could run a 1000watt bulb and not get the full potential of the spectrum. As it never gets to the required temp to get that full spectrum. But seems we are going down the rabbit hole here. The question was whats the best lighting for her 5x5 tent. In my OPINION its 2 600watt marshydro full spectrums LED. Every one may disagree but with the advancement of LED lights more and more top growers are switching to LED. Im just giving the facts. Reason why i feel led is better for a tent is this
1. Safety. Have u ever had a HPS bulb explode on u it sends toxic gas and molten shards of glass and metal flying what would that do to a plastic tent and some plants in a oxygen rich sealed tent???
2. It pulls a lot of power and using alot of power sends red flags to the power company they send reports to the law enforcement I don't know how legal it is where you're going but I know that growing is legal in my state but you still don't want law enforcement checking in on you to see if you're code compliant by the way you have to be code compliant I don't know any fire marshal in the United States that would approve a thousand watt HPS light in an enclosed area just saying I know this because of my employment we won't get into that
3. You don't have to keep buying HPS bulbs every Fugue Rose a LED light is over 100000 hours of usability.
4. You can use the same light for seating vegging and flowering all you have to do is raise or lower the lights
At the end of the day it really only matters to personal preference do a little research and make an educated decision
hi thankyou for your input. can i ask what do you recommend me put in my 5x5x7ft high tent. i too want to save on electric . what is best LED to go with 2 x 600 MARS ?And for the record im not saying LED is better or is not better than HPS im saying it is better in the consumption of power compared to out put. But i will say this LED is scientifically designed to put out the UV spectrum that plants need and thrive in. They work for me do the research and come up with your own opinion I would say if you are a small casual tent grower LED maybe a viable option due to the power consumption heat output and color spectrum
so much wrong with that sentence.They are one of the top rated led makers 4.5 out of 5 kinde being 1st
hiLED components are far more expensive than HPS... While LEDs are solid-state, the number of components in the system is significantly higher. This higher component count leads to to a lower mean time between failure (MTBF)... In theory, a lower MTBF means the system will fail more frequently... I have experienced more failures with LED than HPS and I use LED very little. (Sometimes theory and reality match...) I've never broken an HPS bulb over the last six years... I must not be as clumsy as I thought! You seem to be under the impression that LEDs magically give you light energy without electrical energy... sorry to burst your bubble! Many LEDs caution you not to run them more than 12 hours on-time making these useless for veg... Considering how well they make my flowering plants grow leaves I would definitely use them in veg... (I want a light that makes my plant grow flowers... Best of luck!
what is your budget? has anybody asked?hi
what lights can you recommend i use , what would you go for in a 5x5 x7 high tent ?