I pieced everything together with the help of
@robincnn, Basically everything except the drivers and COB's themselves came from him. Obviously the frame parts and the rivets and what not did not come from him, although the frame for the veg light did. As for cost I will have to tally it up man and see what these two lights plus the veg light came out to. I'm super stoked just got it all buttoned up and the lights are warming up and the dimmers work independently but both bars are on one plug as if they were one light. I need to get a 240V kill a watt to see what she draws at the wall. But I can't find one anywhere........all I see is the euro stuff and it's not the same.
I switched my veg light back over to 120V so I can run it independent of the light controller and got my 120V kill a watt on it and on full blast she's pulling 275 watts from the wall so that was a surprise I got a bit more juice than I was expecting there. Been a long ass night and now it's time for a 7 am coffee and I think I earned myself a phat blunt with some wax rolled up in it to chill for the AM.
My mind is mush and all over man so not sure if I covered everything you asked.
As for the lights, the specs are the following:
- Veg
4- CXB 3590 5000K
1- Mean Well 240-1750B
1- Mod 420 Frame
4- Khatod Lenses
4- 140mm Pin Heat Sinks
4- Bender COB Holders
- Flower
8- CXB 3590 3000K
2- Mean Well 320-2100B
8- Khatod Lenses
8- 140mm Pin Heat Sinks
8- Bender Cob Holders
Plus the usual misc stuff, screws, thermal paste, chains to hang, angled aluminum for frames, etc, etc. And the junction boxes and wago connectors of course. I soldered all the inter COB connections and used wagos everywhere else on connections that might change and for the connections inside the junction boxes.
A couple of pics and it's time for a union break lol........
View attachment 3807021 View attachment 3807022View attachment 3807114