Hi guys,
I am working on designing my own heat sinks for 3590. Attaching is a pic of 5.886'' From HeatsinkUSA with my poor unprofessional drawing. Any comment or advice is very much appreciated.
1-2: Good or Bad to add the short curve reflector thing on the side? The idea is to prevent the light leak. If its good, 1 or 2? 2 is curved, angles to be determined.
3-4, Making T shape thing connector, In case I want to put 2 together into a panel.
5, Make the base thicker from 0.27 to 0.375
6, make some small holes at each end of the sink for hanging purposes. Could make some in the middle too to tie the drivers.
Plan to make this 36 inch long for 4 CXB3590.
I am working on designing my own heat sinks for 3590. Attaching is a pic of 5.886'' From HeatsinkUSA with my poor unprofessional drawing. Any comment or advice is very much appreciated.
1-2: Good or Bad to add the short curve reflector thing on the side? The idea is to prevent the light leak. If its good, 1 or 2? 2 is curved, angles to be determined.
3-4, Making T shape thing connector, In case I want to put 2 together into a panel.
5, Make the base thicker from 0.27 to 0.375
6, make some small holes at each end of the sink for hanging purposes. Could make some in the middle too to tie the drivers.
Plan to make this 36 inch long for 4 CXB3590.
Attachments
-
1.4 MB Views: 50