well i bent 2-3 of the tallet ones, maybe ill stop and lst later if i have to, i wonder if they will stretch much more.LST.
ive maxed the light out, sittin 13" from closest tallest budsite...Yes, they will usually stretch from 14 -21 days.
I would get the light attached directly to the ceiling ASAP. Put the shorter plants directly under the light and the taller ones around the edges.
Re-stake, super crop, tie-down if the tops get too close after ^^^^
thanks, got them all sitting around 16" away from the light with temps around 83-84, i suppose this will have to do, if they stretch more, i will just tie them probably thanksI would just check them once a day during the remainder of stretch and adjust the height of the plants as necessary. Try super cropping a couple of plants and try tying down a couple more and see what works best for your situation. Try drilling a hole through the rim of the pot to tie a string onto and use that sting to pull the top down away from the light.
its day 13 of flowerWow! You need to tie them branches down and flip to flower asap because those will stretch like no tomorrow!
Sorry, didn't realize.its day 13 of flower
They should be almost done. I'm growing a plant which is at 14 days since 12/12 and it hasn't stretched in a day or two.its day 13 of flower
ok cool thanks..They should be almost done. I'm growing a plant which is at 14 days since 12/12 and it hasn't stretched in a day or two.
Looks a lot better. Temps are running a little hot though, can you get them down to the mid 70's?thanks, got them all sitting around 16" away from the light with temps around 83-84, i suppose this will have to do, if they stretch more, i will just tie them probably thanks
i wish, i have a passive intake in the door, and i smashed bricks out to make another one, not sure what else to do lmfaoLooks a lot better. Temps are running a little hot though, can you get them down to the mid 70's?
Ditch that passive inlet and install an inline fan with a speed controller. I'm using a 6" Vortex exhaust and another 6" Vortex for an intake, both on speed controllers. The speed controllers should allow you to dial in the temperature and air flow.i wish, i have a passive intake in the door, and i smashed bricks out to make another one, not sure what else to do lmfao
Heres what i do. Simple bend and tie over.ok cool thanks..
im using two 1ks.. about 16"
anyone similar ?