Moon rocks/caviar

Equinox911

Well-Known Member
I have to try making this!

Are you guys using the same strain of bud as used to make the Kief, oil or shatter?

I am going to try making this with materials all from one strain as well as mixing it up to see what flavor comes out?
 

Joedank

Well-Known Member
I didn't actually smoke any, my wife did though and she said it got her blasted. She just threw it in a bong
WTF do you charge for all the work??
i have heard of folks taking whole runs and with the TANE still a little frothing rolling the nugs then pulling them with a strainer dry a little then roll in keif . THEN into the vac oven with no heat just vac...
it was a pro looking coating job for sure . looked GLAZED...
 

707humboldt

Well-Known Member
WTF do you charge for all the work??
i have heard of folks taking whole runs and with the TANE still a little frothing rolling the nugs then pulling them with a strainer dry a little then roll in keif . THEN into the vac oven with no heat just vac...
it was a pro looking coating job for sure . looked GLAZED...

Thats a good way to try. Id be curious if it would fully purge with out heat though. Im going to try in and bring it to the lab to see.
 

Joedank

Well-Known Member
Thats a good way to try. Id be curious if it would fully purge with out heat though. Im going to try in and bring it to the lab to see.
yea buddy you do that an report back PLEASE i gotta know for sure if its below the 250ppm hydorcarbon level...
kids that do this are PROS but care little for the custies so not sure if the tech is on point...
 

bulimic

Well-Known Member
i'm going to the clinic tomorrow to handpick some buds to try the melt in a spoon then roll it method. i'm going to roll it in the heated BHO, then let it soak in and dry on some parchment paper, or maybe on my silicon baking dish, then when it's dry roll it in heated BHO again to get it to soak in as much area as i can.
 
Top