My 2nd Grow - Aeroponic 300W LED from AdvancedLEDgrow.com

[Edge7]

I learned a lot with my first grow....hoping to get more yield in my 2nd grow. Same set up 2'x4'x5' grow tent, 300W LED from AdvancedLEDgrow.com, set up modeled after seemorebuds grow op, AN Sensi A & B for vegging, Dyna-Grow Bloom and AN Big Bud for flowering. Here's the set up:



Flower - 14 days from the flip on these clones - White widow, northern lights and aurora from Nirvana.

 

[vostok]

Doing a scrog with a LED and a bubble cloner too, see the margins are burnt already ...indicates you are still dialing in the nutes ..? if in doubt flush
to my blog: https://www.rollitup.org/blogs/blog32237-flush-baby-flush.html

 

[Edge7]

Doing a scrog with a LED and a bubble cloner too, see the margins are burnt already ...indicates you are still dialing in the nutes ..? if in doubt flush
to my blog: https://www.rollitup.org/blogs/blog32237-flush-baby-flush.html

Those edges were like that in my smaller Clone tent where the 150W LED light was closer. I flushed them for a couple of days when I moved them over to my flower tent and upping the nutes gradually in stages from 170 to 420 ppm currently. I also added some cal-mag. The new growth is green so I think I'm ok.

 

[foreverflyhi]

Hey homie, ur plants, need help. I suggest u once agian lower ppm,
do u use cal mag? If so how much? If not, why not? Just tryna help

 

[Edge7]

Hey homie, ur plants, need help. I suggest u once agian lower ppm,
do u use cal mag? If so how much? If not, why not? Just tryna help

I added 19 ml of Botanicare Cal-Mag Plus in a 12 gallon reservoir the last 2 days. Last week I added 8 ml of Cal-Mag.

 

[PetFlora]

As below, so above

Root pics please

I can tell you from experience that lpa is far from ideal

It over wets the roots creating long soggy spaghetti instead of a nice ball of soft fluffy roots loaded with fish bones

The plants are so close together that interlocking roots is assured.

How will you remove sick plants without affecting the surrounding plants?

If you cut them, the roots will rot inside the tote

 

[Edge7]

My camera always underexposes my cannabis pics. I think the spacing is ok. Lpa is straight forward and low maintenance easy peasy lemon squeezy.

 

[PetFlora]

You can max lpa by using a deep cycle timer which allows for multi-SECOND on times. From personal experience ~ < 30 seconds, and more like < 15. Repeat frequency depends on RH and temps, but ~ 1 minutes

 

[Edge7]

I'm running 45 second intervals, 1 on, 5 off cycles.

 

[neo12345]

Nice looking set up there Edge, shame about the light though! tee hee

 

[Edge7]

Flower Day 22 from clones, pH 5.7, nutes 450 Big Bud, Dyna-Grow Bloom, Botanicare Cal-Mag:

 

[mnixon]

Your roots may get trapped in your misters. you may have to go with the red misters without the moving parts they cost a little more but worth it in the long run..

 

[Edge7]

Your roots may get trapped in your misters. you may have to go with the red misters without the moving parts they cost a little more but worth it in the long run..

So far no worries the misters are working fine, much better than the ez clone misters I initially tried. Here are the clones at 32 day since the flip. The flowers are bushier, stickier and smellier than my 1st grow:

 

[District]

This doesn't look like a TAG. I think in soil after 32 days my buds were along the same lines in term of size perhaps a little bigger. Stupidly im looking to jump from soil straight to TAG and im currently just sucking up all the info I can. Looking at your roots it doesn't look like the psi at the misters is adequate. Aswell as the roots touching the reservoir. Anyway I wish you all the best.

 

[uncleholdout]

dude it looks sweet. keep up the good work. make sure to post some harvest pics. im curious to see the gpw with led and hydro.

 

[Edge7]

Flower Day 45. I am getting some burn all over my scrog. I have kept my nutes under 500 on this grow and have used AN Big Bud, Dyna-Grow Bloom and a little Botanicare Cal Mag. My 300W LED may be too close as the flowers have bloom to close to 17" from the scrog. I raised it to 20" today. This clone grow appears to mature faster than my first grow.







Next set of clones - Day 35:

 

[Edge7]

Harvest 1 1/4 lbs wet on flower day 54 last week. Onto my 3rd grow.