Urgent!! Can I decarb after adding coconut oil
- Thread starter S. African grower
- Start date
GBAUTO
Well-Known Member
Sure.
I turn my flower into oil using ethanol extraction. I then use that for dabs/vape as well as in my CCO. I just measure out the amount of rosin I want to use and then mix it with the appropriate volume of oil in my trusty rice cooker. I normally let that heat cycle for a couple of hours and then put it into capsules. Works VERY well.
I turn my flower into oil using ethanol extraction. I then use that for dabs/vape as well as in my CCO. I just measure out the amount of rosin I want to use and then mix it with the appropriate volume of oil in my trusty rice cooker. I normally let that heat cycle for a couple of hours and then put it into capsules. Works VERY well.
OldMedUser
Well-Known Member
You need to get the temp up to around 240F for it to properly decarb. Bubbles will start forming around 235F and I heat mine to 260F and go until no more bubbles. I use a variac at 120% to heat my crock pot up higher than it gets just plugged into the wall but an oil bath on the stove will do the trick. Larger pot with cheap cooking oil to set a smaller pot in that has the coconut oil FECO in it. Just an inch of cooking oil is enough but put some bent up coathanger wire on the bottom so the small pot isn't in contact with the bottom of the large pot.