hello guys, i cut clones from my mother plant every 2-3 weeks.
i use SERADIX B cloning powder and normally hava a success of about 80% in total clones which get roots.
but this week, i cut the clones and do same steps as before. but after four days the clones started to crack at 90degress. see the picture below.
all of my 40 clones are showing the same characteristics = bending at 90degress.
could anyone help me with this issue. your advices are really appreciated.
more information =
mother plant is under a 400w hps.
cut the clones every 2-3 weeks, dip them in the seradix powder, place them in the jiffy pellets, finally put them under a dome exposing them to a 400w hps about 2-3 metres away for 18hours everyday.
troubles =
small clones starting to tilt down, but after 2weeks, some are straight and others are as if broken at 90degrees.
could anyone tell me when am i doing it wrong,
i use SERADIX B cloning powder and normally hava a success of about 80% in total clones which get roots.
but this week, i cut the clones and do same steps as before. but after four days the clones started to crack at 90degress. see the picture below.
all of my 40 clones are showing the same characteristics = bending at 90degress.
could anyone help me with this issue. your advices are really appreciated.
more information =
mother plant is under a 400w hps.
cut the clones every 2-3 weeks, dip them in the seradix powder, place them in the jiffy pellets, finally put them under a dome exposing them to a 400w hps about 2-3 metres away for 18hours everyday.
troubles =
small clones starting to tilt down, but after 2weeks, some are straight and others are as if broken at 90degrees.
could anyone tell me when am i doing it wrong,
