Trouble cooling 4 1000watt hps!

Hey guys im currently running two 14000 btu ac's each can cool an area of 500 square feet my tent is 100square feet.
I have 4 separate inline fans (one for each light) they are blowing are across the lights.
I am exhausting all hot air out of the room but it still wont cool luckily im not in my flowering stage yet temps are getting into the low 90s.
Any help will be greatly appreciated thank you.
:eyesmoke:
 

patrickkawi37

Well-Known Member
Hey guys im currently running two 14000 btu ac's each can cool an area of 500 square feet my tent is 100square feet.
I have 4 separate inline fans (one for each light) they are blowing are across the lights.
I am exhausting all hot air out of the room but it still wont cool luckily im not in my flowering stage yet temps are getting into the low 90s.
Any help will be greatly appreciated thank you.
:eyesmoke:
Are you growing in hell? With proper inline fans and insulated ducting .. And two 14k btu units I'd say you have plenty of cooling action. But so you know those acs are quite garbage . When you upgrade to building a room go with a mini split Ac.
 

bryangtho

Well-Known Member
I run 9x600 hps with bat wing it can get very hot here over summer. I don't use any AC at all but I use 4x10 inch fans 2 in and 2 out each pulls 1019 cfm. The 2 fans coming in the air is been drawn from under the house. The other 2 fans with filters on them drawing the air out through the roof.
It runs prefect and most of the time I only run 2 of the fans
 

coreywebster

Well-Known Member
Hey dude. This is above my experience level with all that ac and that any 1000watts but theres defo something wrong.
Post some pics if possible and describe how you vent out or where the hot air goes and where your cool air comes in. As said above a sealed room with that set up shouldn't be that problematic let alone a vented one.
 
Got the temp down to 86 by rearranging my ac units im planning on running co2 would that be an ok temp to run with?
If not i will probably drop two of the thouies to 600s and see what that drops me too.
I appreciate all the help hopefully i can figure this out.
 

MarcMellow

Member
From what I have read 86 is an acceptable temperature if you have CO2 enrichment during the vegetative stage, but I don't think you would want to carry that all the way through flowering. Below is a general recommendation for a DWC setup, and as the graph shows, they like to start with the higher temp and drop from there.
Hope that helps!
 
Thank you all for the responses!
I suppose i still have some things to change then.
Temp finally dropped to 82 last night by adding bigger oscillating fans.
Still debating on dropping two of the thousands to 600s anyone have any suggestions?
 

ttystikk

Well-Known Member
Something is seriously wrong with your setup somewhere.

Be certain that you aren't accidentally drawing air into your space that's been heated by the AC units.

In fact, with 28K BTu why are you drawing in any outside air at all?

Please don't tell us you have the WHOLE AC UNIT INSIDE?! You know they make more heat than cold, right?
 

420producer

Well-Known Member
Something is seriously wrong with your setup somewhere.

Be certain that you aren't accidentally drawing air into your space that's been heated by the AC units.

In fact, with 28K BTu why are you drawing in any outside air at all?

Please don't tell us you have the WHOLE AC UNIT INSIDE?! You know they make more heat than cold, right?
im thinking the same thing.
 
Top