Giant
Active Member
Oh thats right folks, with "Take 2" winding down to a close in the next month or so I am beginning the planning stages of ver. 3.0. This will be my push out of the closet and in to a perpetual grow with two freestanding cabs and possibly a mother/clone area. The cabinets will probably be about 3.5ft deep by 5ft long and 8ft high.
As for the hardware I have my existing 600w HPS w/ digital ballast from HTG. I will probably get a MH conversion bulb and use that for my veg side, and get a Lumatek 600w HPS for my flower room. I currently have a 424cfm fan with carbon scrubber and I will probably double it. I was thinking about using one ventilation system, but it may just end up being easier to do it separately.
This is just a very rough drawing show the cabinets at 4' x 6' x 8'. These will probably get scaled down in the length and width departments as described above. The area in the middle shows shelving, but I may use that for my mother. The top section will play host to my inline fans, wiring, and ballasts.
Any thoughts so far?
As for the hardware I have my existing 600w HPS w/ digital ballast from HTG. I will probably get a MH conversion bulb and use that for my veg side, and get a Lumatek 600w HPS for my flower room. I currently have a 424cfm fan with carbon scrubber and I will probably double it. I was thinking about using one ventilation system, but it may just end up being easier to do it separately.
This is just a very rough drawing show the cabinets at 4' x 6' x 8'. These will probably get scaled down in the length and width departments as described above. The area in the middle shows shelving, but I may use that for my mother. The top section will play host to my inline fans, wiring, and ballasts.
Any thoughts so far?
