SirNastyFinger
Well-Known Member
Hey guys,
I'm finally ready to start my 1000w grow...and after months of research and slowly gathering info and equipment...I have a minor issue.
I am using a General Hydroponics Rainforest hydroponic system(6 sites with vortex sprayer). The system has 6'' baskets that have cocotek liners, which hold hydroton pebbles.
My seeds are fully germinated (all from Greenhouse Seeds Via Attitude)...and rockwool has been sitting in CLEAN, purified water for 36 hours. My plan is to put my germinated seeds IN the rockwool...then place the rockwool into the Hydroton where it will get water through the sprayer hitting the bottom of the basket.
My problem is this...
I have set everything up..and am doing a dry run without the rockwool & seeds. After the system has been running for ONE FULL HOUR...the hydroton is not wet at all. When I remove the basket from the system...it is VERY wet and dripping...but the water does not seem to be penetrating the COCOTEK LINER (used to keep the medium from falling in to the res). Should I remove the cocotek liners? Should the system be left on longer to let the water penetrate the coctek linrer? Should I only use a little bit of hydroton and have the rockwool towards the bottom of the basket where it is more likely to get wet?
The rez has exactrly 13 gallons of water (as per the instructions). The sprayer IS working.
Any help would be GREATLY appreciated guys! Thanks
I'm finally ready to start my 1000w grow...and after months of research and slowly gathering info and equipment...I have a minor issue.
I am using a General Hydroponics Rainforest hydroponic system(6 sites with vortex sprayer). The system has 6'' baskets that have cocotek liners, which hold hydroton pebbles.
My seeds are fully germinated (all from Greenhouse Seeds Via Attitude)...and rockwool has been sitting in CLEAN, purified water for 36 hours. My plan is to put my germinated seeds IN the rockwool...then place the rockwool into the Hydroton where it will get water through the sprayer hitting the bottom of the basket.
My problem is this...
I have set everything up..and am doing a dry run without the rockwool & seeds. After the system has been running for ONE FULL HOUR...the hydroton is not wet at all. When I remove the basket from the system...it is VERY wet and dripping...but the water does not seem to be penetrating the COCOTEK LINER (used to keep the medium from falling in to the res). Should I remove the cocotek liners? Should the system be left on longer to let the water penetrate the coctek linrer? Should I only use a little bit of hydroton and have the rockwool towards the bottom of the basket where it is more likely to get wet?
The rez has exactrly 13 gallons of water (as per the instructions). The sprayer IS working.
Any help would be GREATLY appreciated guys! Thanks