How did i do? Iso oil
- Thread starter chronicvanisland
- Start date
chronicvanisland
Active Member
chronicvanisland
Active Member
chronicvanisland
Active Member
I used pyrex but i have animals
i pulled out any hairs but theres prob lots of shit in it, no bud wash initially either. But dont care cause its dank
i pulled out any hairs but theres prob lots of shit in it, no bud wash initially either. But dont care cause its dank
chronicvanisland
Active Member
Gets me right high
chronicvanisland
Active Member
Just heat i am using, once i felt it was done in pyrex, i scraped it out with narrow dry wall scraper and heated it up with lighter and dripped onto a bottom of a pop can, then i put on a toaster oven vent on top for another 2 hrs, set at 450° getting the " final evaporation to happen", this is my first time making it so idn. Used 450° for temp with dish on it as well for 3hrs, then proceeded to scrape and so on.
Last edited:
chronicvanisland
Active Member
chronicvanisland
Active Member
chronicvanisland
Active Member
chronicvanisland
Active Member
JohnDee
Well-Known Member
Sounds like it worked for you. I mostly do edibles so after evaporation...I dissolved it into oil and made cookies with it. Mine looked similar to yours but a little smoother. Same color.
The weed was a strong sativa...and one single qwet wash (test run) using freezer method gave me 30 cookies...each of which give me a great sat high lasting 4 or 5 hours. (ate 2 yesterday) Plus I still have a gram or so left. I'm happy with these results.
Good luck,
JD
chronicvanisland
Active Member
Just tried that and its dank!!
JohnDee
Well-Known Member
chronicvanisland
Active Member
Its super dank, thanks man you too!
chronicvanisland
Active Member
Super stone
y
y
chronicvanisland
Active Member
Thundercat
Well-Known Member
Congrats on your first batches!! The color looks good for first attempts , and I'm sure it will get you high.
Personally I have found I GREATLY prefer a no-heat/VERY low heat evap. If you place a filter or screen over your pyrex dish and blow a fan on the alcohol it will speed the evap, and you can evap the dish down to a dry crystal in about 24 hours. This method of not using heat retains more terpenes and I find gives a better texture to the final concentrate. Once you evap to the dry stage just scrape it with a razor and enjoy. If you scrape it onto a piece of parchment paper you can use your fingers and melt the crystals together into a solid mass. Usually that mass becomes a nice shatter, once in a while it will turn to wax depending on some variables.
There is a tutorial on how I make my QWISO in my sig line if you wanna see the whole process I use.
, and I'm sure it will get you high. Personally I have found I GREATLY prefer a no-heat/VERY low heat evap. If you place a filter or screen over your pyrex dish and blow a fan on the alcohol it will speed the evap, and you can evap the dish down to a dry crystal in about 24 hours. This method of not using heat retains more terpenes and I find gives a better texture to the final concentrate. Once you evap to the dry stage just scrape it with a razor and enjoy. If you scrape it onto a piece of parchment paper you can use your fingers and melt the crystals together into a solid mass. Usually that mass becomes a nice shatter, once in a while it will turn to wax depending on some variables.
There is a tutorial on how I make my QWISO in my sig line if you wanna see the whole process I use.
Similar threads
