Hey guys this is my first time doing a legitimate grow.(My only other attempt was 15yrs ago with 3 plants grown outdoor.
This is what I have so far:
Sunhut XL- 4x4x7
Sun Systems 10 Crop master ballast
Sun Systems Yield master 2 hood
600w hps bulb
Active Air 6" inline fan 400cfm
6 individual General Hydroponics Waterfarms (The self contained ones not the ones that share a resevoir)
25ft 6" flexible ducting
Liquid ph tester with ph up/down
Temp/humidity display
6 4" air stones
25ft clear air pump tubing
Assorted tubing tee's
2 20 gallon fish tank air pumps to run the air stones
Timer for lighting
Oscilating tower fan
Things I still need to get:
Carbon filter
Speed controller for fan
Cleaning solution
Nutrients (Unless the ones that come with the waterfarm kits are worth using)
ph/ppm testing pen (Unless the kit I have is accurate)
So far I have the tent assembled and the hood/light hung. I drilled bigger holes in the upper buckets for the water farms.I also added a few extra holes.
My immediate goals are to find out what filter I should use.Figure out the routing I should use for my ventilation/cooling system then install it.Figure out an appropriate cleaning solution for cleaning the tent/buckets/equipment so its ready for use.Determine if the nutrients that come with the waterfarms are good to use if not get the right ones.I also am on the fence about if I should add the air stones to the waterfarms.
I would basically like to get the whole system up and running without plants for a couple days to get it all dialed in.Then the beginning of next week start visiting my local dispensaries to find out which clones are available and looking the best.That way I could have it all going by the beginning of october.
I look forward to any advice or criticism.Thanks
This is what I have so far:
Sunhut XL- 4x4x7
Sun Systems 10 Crop master ballast
Sun Systems Yield master 2 hood
600w hps bulb
Active Air 6" inline fan 400cfm
6 individual General Hydroponics Waterfarms (The self contained ones not the ones that share a resevoir)
25ft 6" flexible ducting
Liquid ph tester with ph up/down
Temp/humidity display
6 4" air stones
25ft clear air pump tubing
Assorted tubing tee's
2 20 gallon fish tank air pumps to run the air stones
Timer for lighting
Oscilating tower fan
Things I still need to get:
Carbon filter
Speed controller for fan
Cleaning solution
Nutrients (Unless the ones that come with the waterfarm kits are worth using)
ph/ppm testing pen (Unless the kit I have is accurate)
So far I have the tent assembled and the hood/light hung. I drilled bigger holes in the upper buckets for the water farms.I also added a few extra holes.
My immediate goals are to find out what filter I should use.Figure out the routing I should use for my ventilation/cooling system then install it.Figure out an appropriate cleaning solution for cleaning the tent/buckets/equipment so its ready for use.Determine if the nutrients that come with the waterfarms are good to use if not get the right ones.I also am on the fence about if I should add the air stones to the waterfarms.
I would basically like to get the whole system up and running without plants for a couple days to get it all dialed in.Then the beginning of next week start visiting my local dispensaries to find out which clones are available and looking the best.That way I could have it all going by the beginning of october.
I look forward to any advice or criticism.Thanks