Diy quantum board want to make sure this is wired right

[MickyMouseSmokeHouse]

I'll be using
1x HLG-240H-48A
4x SI-B8T521560WW

Hopefully you can read my half ass blueprint I drew out. I'll be using 18 ga wire from 16 ga wire blow fast fuse holder to led strip. And I'm unknown of the max current each led strip puts out. So I was thinking on using 1.5a or should I go 2a blow fast fuse. I couldn't find an 1.2amp fuse, that I saw people recommend.

 

[ilovereggae]

Theres a link at top of that product page that takes you to the actual datasheet.

https://cdn.samsung.com/led/file/resource/2019/10/Data_Sheet_F_Series_G3_CRI80_Rev.1.1.pdf

Max is 1800ma per strip for those

 

[7CardBud]

Looks good man... that will run fine. 1.5A fuses are perfect 1.2A is a bit close to running current and could be a PITA.
Two small things I noticed.
Usually the switch goes on the hot main line in a circuit like that.
You can tie all the board negatives together and run one common ground back to the driver for a bit cleaner wiring.

 

[Skunkbudz]

Bump .. does anyone have any experience on how to add these fuses? Any links , videos would be greatly appreciated.

Thx

 

[Rocket Soul]

With a A-type dimming meanwell driver you can set the voltage so that each strip won't get more current than you want. Just trim down with voltage adjustment until you start seeing some fall off in intensity. Use Io adjust to dim in normal operation it's more linear.