DarkWizard021
Well-Known Member
Ok I am torn on this. I am making a aero clone station, but I can't decide if I want to keep a mother, or keep the SoG going by just cloning. I'm not growing any special strains atm, just bagseed, want to try to get into harvest every 2-3 weeks.
My issue is size of grow area, it's a storage building about 10x8.
If I keep cloning the clones, i.e. topping etc, will it get to a point where quality decreases?
I played with the idea of keeping a mother plant and just replacing every so often with a clone, but I don't know if I want to go that far with it right now.
Already have my base flowering setup, 6 site aero/dwc res, 400w mh/hps etc. So I will flower 6 clones at a time. Cloning res will have 24-32 sites to give a good selection, with a 400w veg col and reflector. Nutes are super basic, MG tomato, and of course a cloning solution.
My question to sum it up, clone using a mother? Or just clone off of trimmings, topping etc to keep it going?
Thanks
My issue is size of grow area, it's a storage building about 10x8.
If I keep cloning the clones, i.e. topping etc, will it get to a point where quality decreases?
I played with the idea of keeping a mother plant and just replacing every so often with a clone, but I don't know if I want to go that far with it right now.
Already have my base flowering setup, 6 site aero/dwc res, 400w mh/hps etc. So I will flower 6 clones at a time. Cloning res will have 24-32 sites to give a good selection, with a 400w veg col and reflector. Nutes are super basic, MG tomato, and of course a cloning solution.
My question to sum it up, clone using a mother? Or just clone off of trimmings, topping etc to keep it going?
Thanks