Cloning problems!

I've taken 3 rounds of 4-6 clones and they keep falling over and not rooting.... My temps are in mid 80s and so is humitity
So first I wipe everything down with alcohol and let it dry, I then get my glass of cold/warm water (tried both) I remove the cutting from mother and place it directly into cup.... I trim larger fan leaves and remove it from the cup and make my angled cut and dip into clone-x immediately I then place them into my rapid rooters that have been soaked in pH d water I most inside of dome and start opening vents at day 3 ish and try to open em all the way by day 10 depends on if they wilt at all but within hours of cutting they all droop over and get that cut leaf look to em and never perk back up

if they droop you need either to decrease luminosity or increase rH or saturation of the pads.

After the angled cut Let the cuttings soak in a cup of water for a few hours before you plant them, Make sure when you cut them that it’s right under a node, it helps them root

With practice you will find a method that works for you.

Pictures help...sometimes someone picks up on a simple thing you may have not even thought matters.
Have you tried not trimming the leaf tips and just remove any low leaves that touch ground or rapid rooter?
What is your watering process after you initially put the clones in the rapid rooters and how long between each watering ?
I'm guessing either they are staying wet too long or too much stress.
Best of luck and happy growing.