Just got done building a carbon scrubber for my buddy for use in his grow room using this design. http://www.icmag.com/ic/showthread.php?t=31679
The fan my buddy plans on using is the scythe 120mm 110 cfm fan.
I built the scrubber with the 110 cfm in mind, so I made the scrubber 7 inches long with a 4 inch core.
Was I good pal, or will this not be usable for him?
Thanks guys!
The fan my buddy plans on using is the scythe 120mm 110 cfm fan.
I built the scrubber with the 110 cfm in mind, so I made the scrubber 7 inches long with a 4 inch core.
Was I good pal, or will this not be usable for him?
Thanks guys!
