Search results

  1. sforza

    Rooftop SE Asia

  2. sforza

    Yeah! It's Bud Worm Season. Pics

    I spray in the evening and the morning. No problems. It is not a good idea to spray at night if you have buds, but it is not a good idea to spray in the morning if you have buds either, since the buds act like sponges.
  3. sforza

    DiY LEDs - How to Power Them

    No need to bring politics into it bro. Since we didn't go all green like you Germans, our electricity is less expensive, so we can use more of it, plus our taxes are lower, so we have more money left over to spend on electricity. Besides, when you live in a nice big house on a large lot like a...
  4. sforza

    12xCXB3590 Passively Cooled

    Like me, you are being forced to see how close you can get your lights to the tops of your plants, because you are running out of room to raise the lights. Perhaps if you had kept the light closer to the tops of the plants when they were smaller, they wouldn't have stretched quite so much.
  5. sforza

    12xCXB3590 Passively Cooled

    Are you using the 72V or 36V version of the CXB3590? If you are using the 72V version, can you dim your driver down to 700ma? If not, get a big ass fan or a few little fans blowing on the heatsink and you will be fine.
  6. sforza

    12xCXB3590 Passively Cooled

    Tear The Roof Off The Sucker I think you will find that you can get the lights much closer to the plants without causing any problems and in fact, helping the plants to bud faster. I have a grow space with a very low overhead space so I have been forced to find that you can get CXB3590 COBs very...
  7. sforza

    CXB3590 1500W

    Amazon sells it from a quite a few different suppliers http://www.amazon.com/Mil-Kapton-Tape-Polyimide-Yds/dp/B006ZFQNT6/ref=lp_8104466011_1_5?srs=8104466011&ie=UTF8&qid=1457839890&sr=8-5
  8. sforza

    DiY LEDs - How to Power Them

    Should be fine form what I see: Input Voltage: 90 VAC to 305 VAC. 240 is between 90 and 305 VAC. I like to run the CBX3590 at 1.05 amps. I run four of them at 1.2 Amps and they are nice and bright. I think you will like your results. Jerry will get you your quote quickly. Chinese New Year might...
  9. sforza

    DiY LEDs - How to Power Them

    Thanks PB! After I posted my question and I thought about it, I came to the same conclusion, i.e. that the 72V COB would be twice as bright as each of the 36V COBs. Well, not twice as bright, due to lower efficiency, but brighter and put out more heat. I may put the 72V in the middle of a bar...
  10. sforza

    Pictures of your DIY lights - Post your pics!!!

    Speaking of reflectors: This was one of my first lights, using a Chinese Purple COB, which I have replaced with Cree CXB3590s and Vero 29s. It is just a cob mounted on a CPU heatsink and fan, but I mounted it up inside a cheap aluminum reflector that I picked up at Walmart of Home Depot...
  11. sforza

    DiY LEDs - How to Power Them

    Is there any reason to not run CXB3590 36V and 72V cobs on the same driver? I don't think it should be a problem, but I haven't tried it myself yet.
  12. sforza

    Pictures of your DIY lights - Post your pics!!!

    This post confused the hell outta me... If I were you, I would cut back on the ash and up the consumption of weed.
  13. sforza

    Pictures of your DIY lights - Post your pics!!!

    That table looks right. I used 90 degree reflectors on a couple of Vero 29 COBs and the light spreads out fast. It is only when you put hour hand a couple inches under the reflector that the light is very tight and concentrated. A foot or so below the reflector the light is well spread out.
  14. sforza

    Pictures of your DIY lights - Post your pics!!!

    I bought 6 CXB3590 3000K 36V COBs at the same time and some holders as long as I was going to be paying shipping costs anyway. I think I got 16 or so, so that I have more than I need now and have a stash for replacements or future projects.
  15. sforza

    Pictures of your DIY lights - Post your pics!!!

    I got some of the new reflectors from Jerry. $0.80 per reflector.
  16. sforza

    What do I need for my DIY COB??

    I think you mean famous, not infamous. Infamous means having an extremely bad reputation. Why would you want to buy from someone with a bad reputation? In fact, in my dealings with him, Jerry has been a very polite and reliable vendor giving great customer service and providing a good product...
  17. sforza

    CXB3590 1500W

    Depending on the kindness of strangers...
  18. sforza

    Pictures of your DIY lights - Post your pics!!!

    I like to use reflectors and have ordered quite a few of the new reflectors from Jerry now that he has them available. Even if the reflectors do not do anything to get more lights to the plants, I like the way the reflectors protect the COBs a bit and they also help to keep the light out of my...
  19. sforza

    Pictures of your DIY lights - Post your pics!!!

    Kingbright has their own version of Angelina reflectors for $0.80 apiece.
  20. sforza

    CXB3590 1500W

    I guess you get what you pay for and you are not paying anything for the information, thus...
Top