Search results

It depends on your situation if you have moms it allows you to do a mono crop of one strain and still keep the other genetics going. If you clone off a clone you have to run all the strains all the time to keep the genetics

Looking good. The only thing i would suggest is topping them.

Cutter Electronics Unit 12/ 137-145 Rooks Rd Vermont, Vic 3131 Mob 0417 540 359 Phone +61 3 9873 5088 Fax +61 3 98735099 Email [email protected] I find the best response is calling them

I didnt get a reply and had waited days finally just called them and asked WTF they apologized and parts should be in by friday. It would of been nice to know that parts were on backorder in the first place. Far red leds

I did the same thing but got anodized colored screws found 250 for $25

Is anyone else having issues talking to or getting order update from @welight after placing an order? I placed an order on the 2nd and still waiting for an update if its been shipped. Not answering inbox messages

I would run 30A to it and that would give you a little room to grow.

It is fully loaded and only 100A if you want to add circuits there are a few that can be combined but you really need to upgrade to 200A panel.

I'm in CO and this is the first winter with my mini split. I just put it in the backyard by the garage. We have only had a couple of days that were colder and cooling wasn't needed as much. I only had half of the room running. I built a 2x2 frame with R tech 12" bigger than the mini split with...

The 6/3 cord that you will need has to be ran from the lighting controller to the fuse panel. If you were to use plugs you would need to use a plug that would be rated for 50A . I would say have a look at https://www.wireandcableyourway.com/6-3c-thhn-pvc-tray-cable-with-ground.html for 6/3...

Lets start with the size of the area and then you may mention what cobs you have already and what your target ppfd is? The budget also? for heat sinks http://www.heatsinkusa.com/

Use the diy calculator https://www.dropbox.com/s/hqgj9n5qxb9xrei/DIYCOBLEDCalculator.jar?dl=0

How so??? you can go from 2-8 cobs per driver or more if you want. The elg-240-54-d2 i have mentioned can go as low as 27v you only have to worry if one fails so plan around it

That is still a good way to go.

Or Citizen.1818C4.3000K 108 COBS @2.1A ON 4.9 PROFILE HEATSINK 192 SQ.FT. CANOPY 93% EFFICIENT DRIVER @8.5 CENTS PER KWH Total power watts at the wall: 13168.82 Cobs power watts: 12247 Total voltage forward: 5832 Total lumens: 1690086 Total PAR watts assuming 10% loss: 4645...

:finger: 1125 to be exact for my room :bigjoint::bigjoint::bigjoint::bigjoint::bigjoint:

That ppfd will be about 1100 and since you are adding co2 you will the the most out of it

My suggestion world be the elg-240-54-d2 2 cobs per driver 2.2A :hump: but if I was choosing between the 2 240-1750

http://www.co2meter.com/products/k-30-co2-sensor-module thats the one I got