Recent content by Dan_J

Good info all round, the CBN method is quite interesting, will have to trail that at some stage. So i put my multi cooker on high slow cook mode with water for 4 hours and with 5 minutes remaining on the timer my laser temp gun reads 185F Now other than the oven decarb at 248F my oil infuse...

i used 3.5g of trimmed flower, that i have done in the past which has worked fine. so you use 80g of trim or flower? i have tried no decarb before in a multi/slow cooker some time ago, as i had mixed results i just wanted to decarb in the oven to make sure this time round.

hey gang, So i made a batch last night of just straight coconut oil, i've done this before with success and other times failure ( really need to start logging all my methods), and it was a failure, no effects for the most part. my dosage was fine, the calculated dose was 0.10g per portion of...

appreciate the engagement folks. will trial and see, first incrementally up my ppm till signs are showing burn and see how that goes, then extra cal/mag if i see the need. reason for that method is just to rule out and see what helps . thanks

Howdy folks ;) With all the need for extra cal/mag under LED's i was just wondering if it's because of the spectrum of most LED's or are LED's just super efficient producing more par levels at closer canopy heights due to less heat thus the need to up the PPM's of the complete nutrients not...

or would the cut grass/ hay smell be from too much moisture?

hey, its autumn, nearing winter in my part of the world so room temps are about 12c - 20c (53.6f - 68f) no pictures

hey gang, - so my set up as follows 25/30l drum with metal clamp that holds an air tight seal. bottom is 4 side holes drilled which takes 4-6mm rubber top hat gourmets plumbed to a 800l/h air pump hooked up to an inkbird moisture controller and a vent hole plumbed in the lid. - aluminium fly...

hey thanks for the input. so the light schedule should be fine other than insufficient par/DLI, you thinking stretch? its a very small grow area where i start seeds/ clone/ light veg, as the grow height is not more than 2 foot( or less) which may include the led so at times canopy is a foot to...

so i've got a perpetual grow cycle going and my veg area is growing far too quick for the space. so going off the The Gas Lantern Routine wondering if anyone can see any problem with a 4hr on, 6hr off, 1hr on, 6hr off, 1hr on, 6hr off light schedule? flood and drain, perlite, 100w led dimmed to...

this calmag recipe sounds about right, should be able to use as a liquid concentrate to use just like a store bought version for quick use when needed if using magnesium sulfate as far as i understand can only be used as a ready to use solution eg 2 EC and under, cant be used as a liquid...

@Mont@n@ great thanks, that will keep me on the right track. seems to be a+b at 633ppm with micros at 5ppm which would be 10ppm at 1200-1300ppm of a+b?

great, thanks for the info. have found Bacillus thuringiensis in a power form, will see how it goes.

mosquito dunks wouldn't do any damage to nute solution/ plant if dropped into res/ tub housing roots? can only really find this as in australia https://envirosafeaustralia.com.au/wp-content/uploads/2019/11/Mosquito-drops-EnviroSafe-scaled.jpg i dont even have 5mm of room in my netpot, filled...

will give it a go but most of them are the tub latched onto the roots, which i figure their eating resulting in dead branches