im going to make my own but am not sure the ratio of copper hydroxide to paint. since copper hydroxide is made from lye and copper sulfate its pretty damn cheap to make and latex paint is cheap so im thinkin ill just go though 5 gallons mixing pints with different ratios
I'd ditch the cans and bottles and get some 16 ounce styrofoam coffee cups from the corner store. roots hate light so wont like the bottles and they will like to cling to those ridges when transplanting. definately enough light in there for them probably a tiny bit too much. you could make a 5...
Dutch Dirt:
6 parts canadian sphagnum peat moss
1 part vermiculite
2 parts compost
1 part worm castings
5 parts coarse perlite
1 part mix
combine to make one part mix
2 parts bone meal
1 part blood meal
1 part kelp meal
1 part bat guano
1 part dolomite lime
Mix all together let sit for 2...
4800 lumens is more than enough to root a plant. Usually clones are places on the other side of the room as a normal light i have rooted lots of clones with one 23 watt cfl 4 feet above it and it worked fine
what type of clone box did you make?
Copper and Lye are the main ingredients. I have copper pipes in my house. Used to run a copper still which is heated for extended periods of time and make soap with lye. My balls are still attached to my body and I have no illnesses from soap or liquor... Therefore I assume that it is 99% safe...
Just got another cooler today to make for pics. I have made clones in one of these and another similar type (water cooler version) with a homeade sprayer from a stubby bottle with 3000 holes poked in it but it looks pretty ghetto (cooler was in a fire before i picked it up) It clones just as...
Find any cooler taller than 15 inches
Open the lid.
Cut the bottom of the lid out on the inside of the dropped lip.
Drill holes every two inches in the bottom of the lip.
I use Aqua Via water pumps as they are low heat and only $16 for a 315 gph
Depending on size of cooler you should only need...
The best non leaking device is a cooler with the inner layer cut off with drainage holes drilled into the bottom of the lid seal drop. Impossible to leak in airtight coolers also can keep insulated so if your pump doesnt put out much heat its pretty badass