Just tested the setup using the Continuity setting on my multimeter which shows that all strips can be reached from the point where my driver will be connected. But when connecting the driver with or without dimmer on 100 % nothing happens. What could be the issue ?
Sorry if this might be a bit...
I am planning on building an Led array using 12 Bridgelux EB Gen 2 strips (BXEB-L1120Z-35E4000-C-B3).
I would wire split them into groups of 3, wiring them in parallel and then wiring the 4 of them in series.
The driver used will be a Meanwell HLG-480H-C2800B.
This would give each strip 39v...