So I am beginning another run in my 11x22 room and I would like to seal the room this time. I plan to run 6k Hps(part of the room will be used for storage....tanks, reservoir, ect.) I have a 24k BTU mini split and I plan on purchasing a C02 regulator to attach to Titan environmental controller bringing co2 into the room from a tank. I have humidifiers/dehumidifiers. I also plan on purchasing a huge Hyperfan to attach to my huge Phresh filter and putting that by itself somewhere in the room. Am I missing anything?? Thanx for any help. Peace.
your area is to big for tanks to be effective (the tank will be out in matter of few days )
for that size area a propain Co2 burner is a better choice .......the mini split should bebale to handle the heat and RH it puts out
that size u are looking at a 8 or 10 burner uint
the room needs to be sealed .....to do that u can use ploywrap .....it isin the paint section home depot .......6 mm thick clear 20 x100 ft rolls
u need to take one peice and line the walls putting it up making sure it over laps on the concrete floor (even the door way (u can order a zipper to make way in and out they sell them just for this stuff
wrap it all the way around in one peice then u need to seal the end of it with duct tape......now the floor u can do 2 ways
1 u seal it to the concrete with tape
2 u lay out a peice to use on the floor and seal it to the wall make it a tub
Co2 is a heavier gass so with the walls and floor sealed like that it will pool up in the room ...........u keep the senor for the controller at bud lvl so that lvl of the room has the 1500ppm count the air above it does not matter just that lvl and lower .....so will keep the cost of propain/natural gas low ( if u have one or the other in the house/area u can tie into that line to have a larger supply or u canget propain from any store in 20 lb tanks (these tanks last longer then a Co2 tank )
ok with the filter .....in this kind of room u want the filter to sit on the ground and then the ducting to dump out at the top of the room over the middle of the plants (put on a vent so it spreads out before it falls ) it will move the co2 around like that make a rain/shower/water fall of it going on the plants along with mix cool air into the hot air helping cool the room
