Dab Rig chipped! Is it fixable?

C

Ca$hMonay

New Member
So here's the story-
My nail was stuck on my dab rig pretty good so I heated up the nail and slowly tried to take it off but instead the male attachment on the rig got stuck inside the nail and broke off. Bright side is that it isn't too bad but it's not usable at the moment. I was thinking of getting a female to male attachment and putting it over the broken part.
Let me know what you guys think I should do if you have any ideas.
Any help will be greatly appreciated, thanks!
(Pic below)
 

Attachments

WarMachine

WarMachine

Well-Known Member
I personally would do what you are saying, getting a attachment, female to male. With the actual piece that is broken though, I would take a nail file and gently file it down to make it all even. After that, with fine sandpaper (1000 grit) I would go around it to make it nice and dull. That is what I did to my piece when that happened and it's still going strong nearly 2 years in. Def savable!
 
C

Ca$hMonay

New Member
WarMachine said:
I personally would do what you are saying, getting a attachment, female to male. With the actual piece that is broken though, I would take a nail file and gently file it down to make it all even. After that, with fine sandpaper (1000 grit) I would go around it to make it nice and dull. That is what I did to my piece when that happened and it's still going strong nearly 2 years in. Def savable!
Click to expand...
I'll do that, thanks!
 
You must log in or register to reply here.
Top