Kief tumbler wanted

Star Dog

Star Dog

Well-Known Member
I don't own one of these I'm putting it out there as an option that doesn't cost hundreds of pounds, there was a round version available with stainless steel mesh iirc.

Alternatively check out bubble magic or hiesenberg.
_20230125_194429 (2).JPG
If you don't want to lay out money you can 1x1mtr screens in suitable micron sizes from ebay.
 
Johiem

Johiem

Well-Known Member
I bought one from France called the "pollinator" and it's performance was, erratic, difficult to control, but if you could get the damned thing out of "fresh hit Crack head" mode it would be pretty good. The motor relies on friction to slow it down. A stable speed motor and its golden. It was like a hundred bucks and I can tell it was 3d printed
 
Blue Pirate

Blue Pirate

Well-Known Member
Johiem said:
I bought one from France called the "pollinator" and it's performance was, erratic, difficult to control, but if you could get the damned thing out of "fresh hit Crack head" mode it would be pretty good. The motor relies on friction to slow it down. A stable speed motor and its golden. It was like a hundred bucks and I can tell it was 3d printed
Click to expand...
It seems there’s no middle ground, either super expensive or low grade quality. I’m considering a DYI…
 
medidedicated

medidedicated

Well-Known Member
Ionno if you seen me do this before. Using hands to agitate over a trim tray was fantastic enough for me over a tumbler. Its almost instant but have to find that fine line between getting as much as possible while not allowing impurities to eventually get through. Great for whatever but can take a step further and press it.

My highest return by dry weight is 37%. This stuff is crazy but its also easy to lose yield and/or get raunchyness from too much impurities. Though still great. I hit the bottom with a massage gun.
 

Attachments

conor c

conor c

Well-Known Member
medidedicated said:
Ionno if you seen me do this before. Using hands to agitate over a trim tray was fantastic enough for me over a tumbler. Its almost instant but have to find that fine line between getting as much as possible while not allowing impurities to eventually get through. Great for whatever but can take a step further and press it.

My highest return by dry weight is 37%. This stuff is crazy but its also easy to lose yield and/or get raunchyness from too much impurities. Though still great. I hit the bottom with a massage gun.
Click to expand...
You could always clean it up further with static electricity but you will lose a bit of yield but as you press lots of it for Roisin if I remember right it probably be a shout for your needs bud
 
medidedicated

medidedicated

Well-Known Member
Thats a good point its worth it because purity is what youre after with sift and bubble rosin. I just gave up on it for flower rosin I found was just fine and easier. I just dabbed some of that and holy cow I might try what you just said sometime to make sure its at least pure tasting. Yield is whatever, I dab it special occasion.
 
You must log in or register to reply here.
Top